ZyXEL Communications P-871M - Manual (Page 4)

P-871M User’s Guide
4
5 Use the included power adaptor to connect the POWER
socket to a proper power source.
6 Push the power switch to the on position.
1.2 CPE Mode
1 Set the CO/CPE switch on the rear panel to the CPE side.
2 Use the included console cable to connect the CONSOLE
port to your computer’s COM port for configuration.
3 Use the included yellow Ethernet cable to connect the
ETHERNET port to your network device, such as a switch.
4 Over ISDN: Use the included gray cable with a RJ-45
connector to connect the DSL port to another P-871M in
CO mode.
Over POTS: Use the included gray cable with a RJ-11
connector to connect the DSL port to another P-871M in
CO mode.
5 Use the included power adaptor to connect the POWER
socket to a proper power source.
3
1
2
4
5
6
CO
CPE