Zanussi ZWD 14581 S - Manual (Page 21)

21
IMPORTANT!
If an incorrect option is selected, the red pilot
light of the Start/ Pause button flashes for 3
times and the message Err is displayed for
about 2 seconds.
11. Select the Delay Start
Before you start the programme, if you wish to
delay the start, press repeatedly the «Delay
Start» buttons and , to select the
desired delay.
The selected delay time value (up to 20 hours)
will appear on the display for about 3 seconds,
then the duration of the programme will appear
again.
You must select this option after you have set
the programme and before you press the
Start/Pause button.
The wash programme can be delayed from 30
min - 60 min - 90 min, 2 hours and then by 1
hour up to a maximum of 20 hours by means
of this button.
Selecting the delayed start:
●
Select the programme and the required
options.
●
Select the delay start.
●
Depress «Start/Pause» button: the machine
starts its hourly countdown.
The programme will start after the selected
delay has expired.
90’
Delay Start
Cancelling the delayed start:
You can cancel the delay time at any moment,
before you press the Start/Pause button.
If you have already pressed the Start/Pause
button, and you wish to cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by
pressing the Start/Pause button;
• press the Delay Start buttons once until the
symbol 0’ is displayed.
• press the Start/Pause button again to start
the programme.
IMPORTANT!
The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the Start/Pause button, wait until the
«Lock» pilot light goes off. After you have
closed the door, press the Start/Pause button
again.
Note!
The Delay Start cannot be selected with
Drain programme.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washer-dryer by pressing the Start/Pause
button.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to Off and then to the new
programme position. The washing water in the
tub will not emptied out. Start the new
programme by depressing the Start/Pause
button again.
Operating sequence
132972390.qxd 18/06/2007 14:06 Pagina 21