Zanussi ZWD 14581 S - Manual (Page 27)

27
Malfunction Possible Cause / Solution
The washer-dryer does not start:
The door has not been closed. E40
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse or the plug fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
Start/Pause button has not been depressed.
• Please turn the selector dial and press the Start/Pause
button again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the
delay start.
The «Child Safety Lock» function has been selected.
• Disable the «Child Safety Lock» fonction .
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked.
E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
E10
• Clean the water inlet hose filter.
The door is not properly closed.
E40
• Close firmly the door.
Something not working
IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed
below.
During machine operation it is possible that the red Start/Pause pilot light flashes, the buzzer sounds and
one of the following alarm codes appears on the display to indicate that the machine is not working.
●
E10 : problem with the water supply
●
E20 : problem with water draining
●
E40 : door open.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
132972390.qxd 18/06/2007 14:06 Pagina 27