Zebra Technologies RW 220 - Manual (Page 7)

7
RW 220 Vehicle Cradle Installation Guide
Required for Installation
• An electrical drill, 1/4”(6 mm) drill bit
• Common hand tools.
• #8-32 Screws or Bolts and appropriate mounting hardware
for securing the Vehicle Cradle
Note: Use of appropriate hardware used to secure the Vehicle Cradle to
the vehicle is the responsibility of the installer
References
• RW Series Quick Start Guide
• RW Series User’s Guide
• RCLI-DC Mobile Charger Installation Guide
• RCLI-AC Charger Installation Guide
Note: Reference documents are available for download at www.zebra.com
Contents of the Package
• The RW 220 Vehicle Cradle Assembly. Two versions are of-
fered:
p/n AK17463-018- Includes the RW 220 Cradle Assembly, a
mounting arm, a base plate and mounting hardware.
p/n AK17463-019- Includes the RW 220 Vehicle Cradle only.
• This Guide is included with both versions.
Installation
Introduction to Installation
The RW 220 Vehicle Cradle allows you to mount a RW 220 printer
into virtually any vehicle.
This cradle does not supply power to the printer. A Zebra RCLI
series Mobile Charger can be used in conjunction with the RW 220
Vehicle Cradle to supply intelligent charging using the vehicle’s
electrical system.
One version of the RCLI Charger supplies an input power cable
that can be plugged into an automotive vehicle’s cigarette lighter.
Caution: Under no circumstances should this equipment be attached di-
rectly to the vehicle’s battery without a proper fuse.
Since each situation or equipment type may pose unique require-
ments, mounting hardware selection and mechanical installation
shall be the responsibility of the installer. Zebra recommends us-
ing self-locking (ESN) nuts, bolts, and/or lock washers for installing
the mount. The Cradle is secured with #8-32 mounting hardware
(4 places).
Note: Hardware used to secure the Vehicle Cradle to the vehicle is not sup-
plied in the installation kit.
continued on next page