Zanussi ZWG 3142 - Manual (Page 14)

72
ENGLISH
8. Altering an option or a programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “Start/Pause”
button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “O” and then to
the new programme position. The washing water in
the tub will not emptied out .
Start the new programme by depressing the
“Start/Pause” button.
9. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
10. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running.
Now you can select a new programme.
11. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
Wait approx. two minutes before opening the door
to give the electric locking mechanism time to
release it.
If the door does not open, this means that the water
temperature is above 55°C, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to “O”. After about 2
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress
START/PAUSE to restart it.
12. At the end of the programme
The machine stops automatically.
If the anti-crease or Nuit silence/Nacht-cyclus
(Night cycle) option has been selected, the END
light remains lit, the “START/PAUSE” pilot light goes
out, the door is locked to indicate that the water
must be emptied out before opening the door.
To do this turn the programme selector dial to “O”
and then to programme Q (drain) or R (spin).
Select the required spin speed by means of the
relevant dial.
Switch the machine off by turning the programme
selector dial to “O”.
Wait approx. two minutes before opening the door
to give the electric locking mechanism time to
release it.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
132986270GB.qxd 09/02/2005 11.29 Pagina 72