How to establish wireless bridge mode – Z-Com R2 Extender User Manual
Page 14
Advertising
How to Establish Wireless Bridge Mode
The R2 Extender supports four operating modes, which are Base Station, CPE, Peer-to-Peer
(CSMA) and Peer-to-Peer (TDMA). Normally, Wireless Bridge is the typical mode on this unit.
Here we will illustrate how to establish wireless bridge connectivity with R2 Extender.
Enter the user name (admin) and password (password) to login and make configurations.
Note:
Due to browser’s security trusted sites, 192.168.1.1 might not able to be opened.
You may choose to continue to the website.
Open
“Basic Setup” in “System”, set the IP address of two R2 Extenders in the same
network segment. e.g. local R2 Extender as 192.168.1.1 and remote R2 Extender as
Chapter 5 Troubleshooting
Page 14
Advertising