Z-Com R2 Extender - Manual (Page 7)

Chapter 3 System Installation
Assemble the Mounting Bracket
1. Place the main bracket into the seating and use a spanner to fasten the bracket to the R2
Extender with M5×16 screws ○ 8 and M5 washers ○ 9 provided in the hardware packets;
2. Assemble the main bracket by placing articulation pole ○ 2 to the T-form bracket ○ 1 via a
M8×90 ○ 4 screw through the insertion axe and fix with the M8 washer ○ 5 , spring washer
○
6 and M8 nut○ 7 ;
Pole Mounting
1. Install the main bracket and the pole mount bar ○ 3 over the top of the pole by securing the
drill holes of the pole mount bar to the main bracket ones and insert two M8×80 ○ 4 screws,
spring washers ○ 6 and washers ○ 5 through the drill holes and main bracket;
Chapter 3 Hardware Installation Page 7