X10 Wireless Technology UR24A - Manual (Page 17)

33 32
2. Press and hold
TIMER until the LED
indicator lights
steadily. Release
TIMER button.
3. Use the number
buttons to enter the
module Unit Code
for the module to be
turned off.
4. Press the desired
function button (e.g.
CH - to turn the
module off after the
preset time).
5. Using the number
buttons enter the
sleep time required
(1 to 99 mins).
6. Press ENTER to
confirm the setting.
C
HANGING THE
X-10 H
OUSE
C
ODE
:
The Learning SuperRemote defaults to
House Code A, and in most cases you
will not need to change this unless you
are experiencing interference from a
neighboring X-10 system.
1. Press and release
the X-10 button.
If you have already installed the
Transceiver Module, you can control it
and other X-10 modules as follows:
1. Press and release
the X-10 button.
2. Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do not
need to enter ‘0’
first for a single
digit number.)
3. Press the appro-
priate button for the
function you require
(see below).
X-10 FUNCTIONS:
On: CHANNEL +
Off: CHANNEL –
Bright: VOLUME +
Dim: VOLUME –
All Lights On: POWER
All Modules Off: MUTE
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
T
O SET THE
X-10 S
LEEP
T
IMER
The X-10 Sleep Timer switches off the
chosen modules after the preset time.
1. Press and release
the X-10 button.
C
ONTROLLING
X-10
M
ODULES