Notes about the remote control transmitter, English, Standby mode – Yamaha RX-V590RDS User Manual

Page 33

Advertising
background image

33

English

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation

Battery replacement

If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes

Use only AA, R6, UM-3 batteries for replacement.

Be sure the polarities are correct. (See the illustration inside
the battery compartment.)

Remove the batteries if the remote control transmitter will
not be used for an extended period of time.

If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.

Remote control transmitter operation range

Notes

There should be no large obstacles between the remote
control transmitter and the main unit.

If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid direct
lighting.

2

1

3

30°

30°

STANDBY mode

While the power is on, pressing the POWER key on the remote
control transmitter switches the unit to the STANDBY mode. (In
this mode, the indicator is half illuminated.)

POWER on mode

STANDBY mode

Remote control
sensor

Within approximately
6 m (19.7 feet)

Advertising