Zoom R24 - Manual (Page 19)

18
A
u
d
io i
nt
er
fa
ce m
an
u
al
NOTE
• If the Monitor button is on, the R24 input signal
and the signal returning to the R24 via the
computer will both be output from the R24 at
the same time. This can create a flanger-like
sound. To monitor accurately while adjusting the
recording level, turn the
BALANCE knob toward
DIRECT.
• The meter above shows the signal level after it
has been processed internally by Cubase LE 5.
For this reason, a slight delay might occur from
the time a string is plucked until the level meter
moves; this is not a defect.
Adjust the recording level
9
While playing the instrument,
adjust the R24 input level and set
the Cubase LE 5 recording level.
The recording level for Cubase LE 5 can be
checked by viewing the level meter of the
corresponding channel of the recording-enabled
track Please set it as high as possible without
making the meter peak
When adjusting the level, do not move the Cubase
LE 5 fader, but instead use the fader and adjust
the gain on the R16
Level Meter
10
11
After adjusting the recording level,
click the Monitor button to turn off
the light.
Monitor
button
This turns off display of the input level, and mutes
the signal from the computer to the R24
When the Monitor button is off, the signal just
before it is sent to the computer can be monitored
from the R24
PHONES and OUTPUT jacks
Confirm that the Transport Panel is
displayed
If the Transport Panel is not displayed, select
“Transport Panel” from the “Transport” menu