Zanussi ZWF 14581 W - Manual (Page 20)

20
IMPORTANT!
The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the Start/Pause button, wait until the
«Lock» pilot light goes off. After you have
closed the door, press the Start/Pause button
again.
Note!
The Delay Start cannot be selected with
Drain programme.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing the
Start/Pause button.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to Off and then to the new
programme position. Start the new programme
by depressing the Start/Pause button again.
The washing water in the tub will not empty
out.
Interrupting a programme
Depress the Start/Pause button to interrupt a
programme which is running, the
corresponding light starts to flash. Depress the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
Start/Pause button.
If the «Lock» light goes off, the door can be
opened.
If the «Lock» light does not switch off, this
means that the machine is already heating,
that the water level is above the bottom edge
of the door or that the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After about 3
minutes the door can be opened (pay attention
to the water level and temperature!).
At the end of the programme
The machine stops automatically. The
Start/Pause light goes off, the «Lock» light
goes off and on the display will appear a
flashing « 0.00 ». The door can be opened.
If the «Rinse hold» or «Night Cycle»
option has been selected, the «Lock» light
remains alight and the door is locked to
indicate that the water must be emptied out
before opening the door.
The display will show a flashing « 0.00 ».
To empty out the water please read the steps
on the Rinse Hold option paragraph.
Turn the programme selector dial to «Off» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
Smart 132973880.qxd 23/06/2008 12.22 Pagina 20