Zanussi ZWF 14581 W - Manual (Page 23)

23
Malfunction Possible Cause / Solution
The washing machine does not start:
The door has not been closed. E40
• Close the door firmly.
The plug is not correctly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
Start/Pause button has not been depressed.
• Please turn the selector dial and press the
Start/Pause button again.
The delay start has been selected.
• If the laundry is to be washed immediately, cancel
the delay start
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked.
E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
E10
• Clean the water inlet hose filter.
The door is not properly closed.
E40
• Close the door firmly.
Something not working
IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes,one of the
following alarm codes appears on the display and 3 acoustic signals sound every 20 seconds to
indicate that the machine is not working.
●
E10 : problem with the water supply
●
E20 : problem with water draining
●
E40 : door open.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If
after all checks, the problem persists, contact your local Service Centre.
Smart 132973880.qxd 23/06/2008 12.22 Pagina 23