Printing a test (printer configuration) label – Zebra Technologies GX420T User Manual
Page 33
21
Getting Started
Printing a Test (Printer Configuration) Label
12/14/07
GX420t / GX430t User Guide
980612-001 Rev. A
Printing a Test (Printer Configuration) Label
Before you connect the printer to your computer, make sure that the printer is in proper
working order.
You can do this by printing a configuration label.
1.
Make sure the media is properly loaded and the top cover of the printer is closed. Then,
turn the printer power on if y ou have not already done so. If the printer initializes with the
status light blinking green (pause mode), press the Feed button once to set the printer in
Ready (to print) mode. See the
if the printer’s status light
does not turn solid green (Ready).
2.
Press the Feed button two to three times to allow the printer to calibrate the printer for the
installed media. The printer may feed several labels during this process.
3.
When the status light is solid green, press and hold the Feed button until the status light
flashes once.
4.
Release the Feed button. A configuration label will print.
If you cannot get this label to print, refer to