Connections to other equipment (continued) – Zenith J3W41321A User Manual
Page 12
12
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound as follows, you can enjoy various audio systems
including Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, or etc as shown below.
Coaxial digital cable
(not supplied)
AV Amplifier with built-in digital surround
decoder as listed above
Center Speaker
Front
Speaker
(Left)
Front
Speaker
(Right)
Subwoofer
Surround
Speaker (Left)
Surround
Speaker
(Right)
COAXIAL DIGITAL
AUDIO OUTPUT
To Coaxial Digital
Audio Input
Rear of the TV
TV
Connections to other equipment
(continued)
NOTES:
•
When you make the connection above, on the AV Amplifier, do not set DOLBY DIGITAL to DOLBY DIGITAL “ON”.
If you do, a loud noise will emit from the speakers possibly causing damage to your hearing or to the speakers.
•
This unit does not apply to DTS audio out. There will be no sound output if connected to AV amplifier with built-in
DTS decoder.
J3W41321A_En_P10-13
24/03/2006, 2:22 PM
12