Preparations and connections, Installing batteries in the remote control, Remote control operation range – Yamaha GX-900 User Manual
Page 12
4
Preparations and connections
1.
Turn the remote control over and remove the battery
compartment cover by pulling it up while pressing the edge
of the cover in the direction of the mark.
2.
Insert the batteries (AA, R6, UM-3 type) according to the
polarity markings on the inside of the battery compartment.
3
.
Attach the battery compartment cover.
Notes
●
Remove the batteries if the remote control is not used for an
extended period of time.
●
If batteries leak, dispose of them immediately. Avoid
touching the leaked material and contact with clothing, etc.
Clean the battery compartment thoroughly before installing
new batteries.
●
Be sure to use the same type of batteries together.
●
Do not use a new battery and an old battery together.
Installing batteries in the remote control
Notes
●
The area between the remote control and the main unit must
be clear of large obstacles.
●
Do not expose the remote control sensor to strong lighting,
in particular, an inverter type fluorescent lamp. Otherwise,
the remote control may not work properly. If necessary,
position the main unit away from direct lighting.
Battery replacement
If you find that the remote control must be used closer to the
main unit, the batteries are weak. Replace both batteries with
new ones.
Remote control operation range
2
1
3
DISC
1
DISC
2
DISC
3
3–DISC VCD CHANGER
DOWN
UP
VOLUME
PUSH OPEN
MINI COMPONENT SYSTEM GX–700
PRESET/ TUNING/ BAND
A/B/C/D/E
DISC CHANGE
OPEN / CLOSE
30
°
30
°
0.2 m – 6 m