ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 626)

ZyWALL 5 User’s Guide
Appendix L Firewall Commands 625
config edit firewall set <set
#> rule <rule #> destaddr-
subnet <ip address> <subnet
mask> This command sets a rule to have the
ZyWALL check for traffic with a particular
subnet destination (defined by IP address and
subnet mask).
config edit firewall set <set
#> rule <rule #> destaddr-
range <start ip address> <end
ip address> This command sets a rule to have the
ZyWALL check for traffic going to this range of
addresses.
config edit firewall set <set
#> rule <rule #> TCP destport-
single <port #> This command sets a rule to have the
ZyWALL check for TCP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
config edit firewall set <set
#> rule <rule #> TCP destport-
range <start port #> <end port
#> This command sets a rule to have the
ZyWALL check for TCP traffic with a
destination port in this range.
config edit firewall set <set
#> rule <rule #> UDP destport-
single <port #> This command sets a rule to have the
ZyWALL check for UDP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
config edit firewall set <set
#> rule <rule #> UDP destport-
range <start port #> <end port
#> This command sets a rule to have the
ZyWALL check for UDP traffic with a
destination port in this range.
Delete
config delete firewall e-mail This command removes all of the settings for
e-mail alert.
config delete firewall attack This command resets all of the attack
response settings to their defaults.
config delete firewall set
<set #> This command removes the specified set from
the firewall configuration.
config delete firewall set
<set #> rule<rule #> This command removes the specified rule in a
firewall configuration set.
Table 30 Firewall Commands (continued)
FUNCTION COMMAND DESCRIPTION