Zyliss PowerLite 835p - Manual (Page 9)

Epson PowerLite 835p
10/04 Epson PowerLite 835p - 9
This automatically resets the projector’s tracking, sync,
resolution, and position settings.
If vertical bands appear in the projected image and pressing
the
Auto button doesn’t correct the problem, hold down the
Shift button on the projector’s control panel while pressing
either the Tracking + or the Tracking - button.
If the image appears fuzzy or flickers and pressing the Auto
button doesn’t correct the problem, hold down the Shift
button while pressing either the Sync + or Sync - button on
the projector.
Shutting Down the Projector
When you’ve finished using the projector, follow the
recommended procedure to shut it down. This extends the life
of the lamp and protects the projector from possible
overheating.
Note: You can set the projector to automatically turn off the
projector lamp and enter “sleep mode” when it has not received
any signals for 30 minutes. This conserves electricity, cools the
projector, and extends the life of the lamp. To start projecting
again, press the P
Power button. If you are done using the
projector, unplug the power cord. To turn off sleep (standby)
mode, see the User’s Guide.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the red P Power button
on the projector or remote control.
You see a confirmation message. (If you don’t want to turn
the projector off, press any other button.)
3. Press the P Power button again. The projector beeps
twice, the lamp is turned off, and the Power light flashes
orange for about 30 seconds as the projector cools down.
After the projector has cooled, the orange light stays on and
the exhaust fan shuts off.
To turn the projector on again, wait until the orange light
stops flashing. Then press the P
Power button.
4. If you extended the adjustable front foot, press up on the
blue foot release lever to retract it.
5. Replace the lens cap and unplug the power cord.
Caution: Turn the projector off when not in use. Continuous
24-hour-a-day use may reduce the projector’s overall life.
6. If you’re using a remote control, set its ON/OFF switch to
OFF .
Auto button
Power button