Zanussi FL 15 - Manual (Page 25)

25
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not
impeded by carpets, rugs etc. Check that the machine
does not touch the wall or other kitchen units.
Never place cardboard, wood or similar materials under
the machine to compensate for any unevenness in the
floor.
Your new machine has been designed to be permanently
plumbed in to your home’s water supply and drainage
system. However, if this is not possible, it may be
connected to a suitable existing tap with the drain hose
discharging into a sink.
Water inlet
Before connecting the hose be sure to fit the mesh filter
«A» supplied as per diagram.
Installation should comply with local water authority
and building regulations’ requirements.
Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring nut
again to prevent leaks.
Water drainage
This appliance is designed to be permanently plumbed
into your home's water supply and drainage system.
The appliance drain hose should hook into a standpipe,
the hook in the drain hose is formed using the plastic
“U-Piece” supplied.
The standpipe should have an internal diameter of
approximately 38mm (see diagram) thus ensuring there
is an air break between the drain hose and standpipe.
When discharging into a standpipe ensure that the top of
the curve in the hose end is no more than 90cm (35.4'')
and no less than 60cm (23.6'') above floor level. The
upright standpipe should have a minimum length of
30cm (12'') from the bottom of the elbow to the top of
the pipe (see diagram).
Make sure that it is designed in such a way, that the end
of the drain hose cannot be covered with water.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece
is available from your local Service Force Centre.
The joining piece must have an internal diameter of
18mm.
If you intend the drain hose to empty into a sink, make
sure that the sink is empty and the plug hole is not
blocked. Use the plastic “U-Piece” supplied.
A
P0003 P0021
P1039
3 pin
Max.
90 cm.(35.4")
Min.60 cm. (23.6")
P1040
Min.
30 cm.(12")
38 mm.(1/ ") diameter
standpipe 1
2
P0022