10 start/pause button, 11 delay start button, 12 operating pilot lights – Zanussi FL 15 User Manual

Page 9: Altering a programme which is running, Opening the door after the programme has started

Advertising
background image

9

10 START/PAUSE button

This button has three functions:

a) Start

After having selected the required wash programme,
press this button to start the machine; the display stops
flashing.

b) Pause

To interrupt a programme which is running, press the
START/PAUSE button: the figures displayed will start
to flash.

To restart the programme from the point at which it was
interrupted, press the START/PAUSE button again.

c) Drain

At the end of a programme which stops with water in
the drum (RINSE HOLD option), or after the soak
programme, press the START/PAUSE button to empty
out the water: after a soak programme, the machine will
empty only; after RINSE HOLD programmes, the
machine will empty and spin.

11 DELAY START button

This button allows starting of the machine to be delayed
by a maximum of 19 hours.

The button must be pressed before pressing the
START/PAUSE button.

The figures indicating the time delay appear in the
display next to the button. After one minute, the
machine starts its countdown (hourly).

During the last hour, the remaining time is displayed
every 5 minutes.

The delay start function cannot be used with the SPIN
and DRAIN programmes.

To alter or cancel the preset delay, press the
START/PAUSE button, then press the DELAY START
button until the required time is displayed or the symbol

0 h if you wish to cancel the delay.
Then press the START/PAUSE button again.

When the delay is cancelled, the display shows the
duration of the wash programme previously selected.

12 Operating pilot lights

The pilot lights come on individually, or in groups,
according to the options selected.

The pilot lights flash for about three seconds if wash
options are incorrectly selected. The message Err is
displayed.

Altering a programme which is
running

To alter a programme, press the START/PAUSE button.
Before the machine starts the heating phase, i.e. within
the first 15 minutes for cotton programmes, 10 minutes
for synthetic and delicate programmes and 5 minutes for
the wool programme, the following parameters can be
altered:

-

Fabrics

-

Temperature

-

ECONOMY or QUICK WASH.

The PREWASH option can be cancelled, but cannot be
added, once the programme has started.

The SPIN option can be modified before the final spin
and the EXTRA RINSE option can be cancelled or
added before the rinse cycle starts.

To restart the wash programme, press the
START/PAUSE button again.

Opening the door after the
programme has started

The door can only be opened before the machine starts
the heating phase (within the first 15, 10 or 5 minutes,
depending on the programme selected - see paragraph
above).

Set the machine to PAUSE (by pressing the
START/PAUSE button).

If the door does not open, this means that the machine is
already heating, or that the water level is above the
bottom edge of the door.

This prevents water from spilling out when the door is
opened.

The door can only be opened when the pilot light next
to the handle goes out.

Advertising
This manual is related to the following products: