Zebra Technologies T300 - Manual (Page 18)

Zebra 6300 Printer User’s Guide
!
Setting Up the Software
Note: If you plan to use BAR-ONE™ software to create your labels, you
will need to install the software on your computer before you can operate
your printer.
You will not need to use BAR-ONE software if you are printing label for-
mats created in ZPL II. To print ZPL II, you may use virtually any text pro-
gram on any computer that will send ASCII text to the printer via either the
serial or parallel port. For more information, refer to the ZPL II Program-
ming Guide (available by sending in the mail-in/fax-in postcard at the back
of this book).
BAR-ONE System Requirements
BAR-ONE software works with most IBM
®
-compatible personal computers
available today. The software may be installed and up-and-running within a
few minutes. Refer to the on-line help system and to the Read-Me file for
further information and/or last-minute updates. The BAR-ONE software
may be installed on any computer that meets the following system require-
ments:
Table 1: System Requirements
BAR-ONE Software Minimum Recommended
Processor
486SX 486SX
Hard disk 3 MB 10 MB
Memory
4 MB RAM 8 MB RAM
Interface
RS-232 Parallel
Display VGA SVGA
Floppy drive
3½”
Operating system Windows™ 3.1 or higher, NT, 95;
OS/2 2.1 or earlier
Mouse
RS-232 or PS/2
547000r1 Page 13 Tuesday, March 25, 1997 11:38 AM