Zebra Technologies T300 - Manual (Page 33)

Zebra 6300 Printer User’s Guide
"
Specifications
Print density 203 dots/inch 8 dots/mm
Print width 1 ² to 4.125² 25.4 mm to 105.0 mm
Print speed 2 ²/sec, 1.5²/sec 51 mm/sec, 38 mm/sec
Label width (including back-
ing material, if any) 1
² to 4.65²
25 mm to 118 mm
Label length 0.5 ² to 18² 13 mm to 457 mm
Interlabel gap 0.08 ² to 0.16² 2 mm to 4 mm
Label thickness (including
backing material, if any) 0.003
² to 0.010²
0.076 mm to 0.254 mm
Label roll
size Max. outer
diameter 4.0 ² 102 mm
Min. inner core
diameter 1.0 ² 25.4 mm
Registration
tolerance Horizontal ± 0.059
²
± 1.5 mm
Vertical ± 0.0393 ² ± 1.0 mm
First dot location (from outer
media edge) 0.060 ² to 0.140² 1.5 mm to 3.5 mm
Ribbon roll
size Max. outer
diameter 1.5
²
38 mm
Min. inner core
diameter 0.50 ² 13.0 mm
Physical size (L ´ W ´ H) 10.1 ² ´ 8.8² ´ 6.2² 257 mm ´ 224 mm ´ 158 mm
Weight (without media) 7 lb 3.18 kg
Tempera-
ture range Operating 40° to 100° F 4° to 38° C
Storage -4° to 140° F -20° to 60° C
Relative humidity, operation
and storage 10 to 90% R.H.
Media requirements Zebra recommends using Zebra-brand thermal transfer media
that is outside-wound (the label or printing surface is wound on
the outside of the backing). Media may be roll or fanfold,
transmissive or reflective (black-mark) sensing; continuous,
die-cut, or notched. Notched media: notch must be 1/4
² wide ´
3/
32² long located on the left side of the label as viewed from
the front of the printer. Black-mark media: marks must be
located within 1 mm of the left edge of the media as viewed
from the front of the printer; mark thickness: 0.12”-0.43” (3
mm - 11 mm); mark width: 0.43” (11 mm) - full media width;
mark-to-mark leading edge registration tolerance ±0.016”
(±0.4 mm); mark density > 1.0 ODU (Optical Density Unit);
maximum density of the back of the media on which the black
mark is printed: 0.5 ODU.
547000r1 Page 24 Tuesday, March 25, 1997 11:38 AM