Yamaha 03D - Manual (Page 21)

16 02R Applications
Yamaha 02R & 03D Applications Guide
3
02R with Two ADATs & JL Cooper Datasync-2
This application shows how the 02R can be used with two Alesis ADATs and JL Cooper
Datasync-2 Synchronizer to create a 24-input, 16-track digital recording system. The JL
Cooper Datasync-2 Synchronizer is a cost-effective device for setting up a synchronized 02R
and ADAT system.
The 16 digital tape returns and 24 Mic/Line inputs provide up to 40 inputs at mixdown. In
addition, the 02R’s built-in automation and scene memory systems provide both dynamic
and static mix automation referenced to MIDI timecode.
Connections
• The ADAT (CD8-AT) cards must be screwed securely in place. Do not leave the screws
out after installation as the cards will not be grounded correctly.
• The Digital In/Out connectors on the 02R and ADAT are connected together using
Optical Cables. Press the DIGITAL IN buttons on the ADATs to use the DIGITAL INs.
• ADAT–A is connected to Slot [1] of the 02R and the tape inputs correspond to tracks
one through eight.
• ADAT–B is connected to Slot [2] of the 02R and the tape inputs correspond to tracks
nine through sixteen.
• The JL Cooper Datasync-2 Synchronizer converts the ADAT’s internal timecode to MIDI
timecode or SMPTE timecode.
• 9-pin Sync cables for connecting the ADATs and Datasync-2 are available from Alesis.
02R Wordclock Setup
ADAT (CD8-AT) cards are installed in Slot [1]and Slot [2], so any pair of the tape inputs
can be selected as the wordclock source on the DIGITAL I/O menu.
ADAT Wordclock Setup
ADAT–A should be set as wordclock master. To confirm this, press the SET LOCATE and
DIGITAL IN buttons together. The display should show “int”, meaning internal wordclock.
The ADAT sampling rate can be set to either 48 kHz or 44.1 kHz. Use Fixed mode for
48 kHz and Variable mode for 44.1 kHz (using the PITCH DOWN button, set to –147 cents.
At which point “–146, 44.1, –148” appears on the display). The newer ADAT-XT has
dedicated switches for selecting these two sampling rates.
Notes
• Press the DIGITAL IN buttons on the ADATs to use the DIGITAL INPUTs.
• ADAT–B must be powered up before ADAT–A, because when ADAT–A is powered up it
checks how many ADATs are connected, allocates them device numbers, and
automatically sets the system word clock. ADAT–A works as Control Master.