ZyXEL Communications omni.net LCD series - Manual (Page 28)

omni.net LCD series Quick Start Guide
3-2
Install INF File
Please note that the omni.net LCD and omni.net M/LCD both lack a USB interface.
Please be aware that these products must be installed via a serial port (RS-232)
interface. The procedure for this installation is listed in the previous section.
If your computer supports Plug & Play, be sure your omni.net LCD+M/LCD is on before starting
your computer. If you are using a non-PnP protocol, then follow the steps below to perform the
installation:
Step 1. Click Start, Settings, Control Panel and then double-click on the Modems icon. Click
on the “Add…” button.
Step 2. In the screen below click the Don't detect my modem; I will select it from a list option
box. Click Next > to continue.
Check this
option button
by clicking
here.
Click Next >.