Zhumell Rangefinder RF645 - Manual (Page 6)

6
Nomenclature
Lens mounting index
(camera body)
Rangefinder
coupling roller
Electronic contacts
(camera body)
Light shielding curtain
Flash synch terminal
Lens Lock pin
Lens lock release button
Rear cover
Pressure plate
Film spool shaft lock
release button
Spool holder
Film start alignment mark
Film type selection lever
Printed circuit cable
Film pressure spring
Light shielding curtain
1. Getting Started 1-1 Loading Batteries
The RF645 will not function without batteries loaded.
1. Appropriate batteries
Load two CR2 type 3-volt lithium battery cells.
2. Open the battery chamber cover
Pull down on the battery chamber lock release and the cover
will swing open.
3. Insert batteries
Insert two cells of the same type of batteries in the same direc-
tion as shown in drawing, directing the plus (+) side toward the
inside chamber.
4. Close the battery chamber cover
Close the chamber cover and make sure the cover is securely
locked. A loosely locked cover may open and drop the batter-
ies in the middle of a shooting session.