Yamaha CRW8824SX Series - Manual (Page 18)

Front and Rear of Unit
Rear Panel
The CRW8824SX drive’s rear panel features the following:
SCSI
SCSI
CDR ID
TERMINATOR
LINE OUT
AC IN
SER. NO. st2
R L
ON OFF
❋❋❋❋❋❋❋❋
1
Serial number
This consists of 3 letters
and 7 digits. You may
need to refer to this number
when requesting User
Support services.
Power connector
Connect the included
power cable here. (P.18)
SCSI connectors
Connect either of these to
your computer’s SCSI
adapter card using the
SCSI cable. The other
connector can be used as a
pass-through when daisy-
chaining more SCSI devices
to it. It can be left vacant if
your drive is the last device
on the SCSI chain and is
terminated. (P.18)
LINE OUT connectors
To listen to audio CDs with
your drive, connect these to
the line-level input (LINE IN)
of your stereo equipment
using a standard stereo
phono cable (sold
separately).
CDR ID selector switch
The drive’s SCSI ID number
is shown in the switch’s
window. Press the button
above the window to
decrement the SCSI ID
number, or the button
below the window to
increment it. (P.10) TERMINATOR switch
This enables the drive’s
built-in SCSI termination.
Switch this to “ON” if your
drive is the last device on
the SCSI chain. Otherwise,
switch it to “OFF.” (P.11)
9