ZyXEL Communications 2864 - Manual (Page 143)

13–5
CALLER NUMBER: 7135551414 or CALLER NAME: Jack Smith
RING
In the multiple message format, if the caller's number and name are available, the
ring message will be:
RING
TIME: MM-DD hh:mm
CALLER NUMBER: <Caller_ID>
CALLER NAME: <Caller_Name>
RING
Following is an example:
RING
TIME: 04-28 12:30
CALLER NUMBER: 7135551414
CALLER NAME: Jack Smith
RING
If the caller number and name are not available, the ring message will be:
RING
TIME: 04-28 12:30
REASON FOR NO NUMBER: OUT_OF_AREA
REASON FOR NO NAME: PRIVACY
RING
The AT*T command will cause the modem to send the last CND message.
Setting S48.0=1 will cause the modem to report CND information in its ASCII
coded hexadecimal raw data format. The DTE software is responsible for explain-
ing the data. Please refer to the Bellcore Technical Advisory AT-NWT-000030
document for the exact data format. The above Caller ID scheme applies to the
North America area. Different countries may employ different Caller ID schemes,
check if the scheme used in your country is supported before using the Caller ID
feature. For most other Caller ID schemes, only the Caller telephone number is
provided.
Distinctive Ring
This is a phone service that may be offered by your phone company. Check your
phone company for availability. With this service, you can have several phone num-
bers assigned to the same phone line. The phone company will send a different type
of ring signal for each phone number being called. The subscriber can distinguish
which number is being called by recognizing which type of ring is being received.