Zanussi ZWF 1651W - Manual (Page 15)

15
9. Select the DELAY TIME
Before you start the programme, if you wish the starting
to be delayed, choose the DELAY option.
The selected delay time value (up to 20 hours) will
appear on the display while selecting.
The end cycle will be updated and shown on the relative
position of the display.
10. Start the programme
Press the Start/Pause button. The relevant light will
stop flashing. The message relevant to the phase that is
in progress will be shown in the display.
If you have chosen a delayed start, the washing machine
will begin the countdown.
11. How to change an option or
a programme during its
cycle
If the programme has already started, before you make
any change, you must pause the washing machine by
pressing the Start/Pause button.
It is possible to change any option before the
programme carries it out.
Changing a running programme is possible only by
cancelling it and selecting a new programme. Turn the
programme selector dial to Off and then to the new
programme position. The washing water remains in the
tub. Start the new programme by depressing the
Start/Pause button.
Change Options Exit
COTTON
Washing
08.30
12.00
40°C 1200
Temp. Spin
START/PAUSE
Change Options Exit
Delay Start
Start in 30 min 11.25
Temp. Spin Change Options Exit
Delay Start
No 10.55
Temp. Spin
Note: To drain the water before starting the new cycle
you have to cancel the programme and select the Drain
programme.
12. Cancelling a programme
Turn the selector dial to Off to cancel a programme
which is running. Now you can select a new
programme.
13. How to open the door
during the cycle of a
programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the relevant message appears in the
display the door can be opened.
Should it not be possible to open the door, the “Door
locked” message appears in the display, should it be
absolutely necessary to do so, switch the machine off by
turning the selector dial on Off position.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
132985250.qxd 19/12/2005 16.58 Pagina 15