Zanussi ZWF 14380 S - Manual (Page 14)

14
Operating sequence
Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
as much as possible. Close the door.
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked .
If required, pour fabric softener into the
compartment marked (the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by turning
the programme selector dial ( )
The green light of the button
starts to flash.
The selector dial can be turned either
clockwise or anticlockwise.
Turn to position «Off» to Reset programme /
Switch OFF of the machine.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
6
1
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red pilot light of button will
flash 3 times and the message Err is displayed
to indicate a wrong selection. The machine will
not perform the new selected programme.
Select the spin speed or Night Cycle or
Rinse Hold option by pressing the button
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate (refer to the
section «Programme table» for the maximum
allowed by each cycle spin speed).
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
speed different from the one proposed by the
appliance.
Night Cycle
: by selecting this option, the
machine will not drain the water of the last
rinse, so as not to crease the laundry. As all
spinning phases are suppressed, this washing
cycle is very quiet and it can be selected at
night or in times with a more economical power
rate. On some programmes, the rinses will be
performed with more water.
When the programme has finished, the display
shows a flashing zero « 0.00 » but the door
remains locked to indicate that the water must
be emptied out.
Rinse Hold
: by selecting this option the
water of the last rinse is not emptied out to
prevent the fabrics from creasing.
When the programme has finished, the display
shows a flashing zero « 0.00 » but the door
remains locked to indicate that the water must
be emptied out.
To empty out the water, see the paragraph
«At the end of the cycle».
2
6
132962510.qxd 01/07/2008 10.04 Pagina 14