Yamaha HTR-6030 - Manual (Page 17)

13
En
Connections
PRE
P
ARA
T
ION
English
■ Connecting to the FRONT A terminals
1
Loosen the knob.
2
Insert the bare end of the speaker wire into
the hole on the terminal.
3
Tighten the knob to secure the wire.
Connecting the banana plug
(except Europe, Korea and Asia models)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables. First, tighten the
knob and then insert the banana plug connector into the
end of the corresponding terminal.
■ Connecting to the FRONT B, CENTER,
and SURROUND terminals
1
Press down the tab.
2
Insert the bare end of the speaker wire into
the hole on the terminal.
3
Release the tab to secure the wire.
1
Make sure this unit is turned off.
See page 18 for details about turning on or off this
unit.
2
Press and hold 0
TONE CONTROL and
then press 1
STANDBY/ON to turn on this
unit.
This unit turns on, an the advanced setup menu
appears in the front panel display.
3
Press A
PROGRAM l / h repeatedly to
select “SP IMP.”.
The following display appears in the front panel
display.
4
Press B
STRAIGHT repeatedly to select “6Ω
MIN”.
The following display appears in the front panel
display.
5
Press 1
STANDBY/ON to confirm your
selection and set this unit to the standby
mode.
The setting you made is reflected next time you turn on this unit.
1
2
3
Red: positive (+)
Black: negative (–)
Banana plug
Red: positive (+)
Black: negative (–)
Setting the speaker impedance
(U.S.A. and Canada models only)
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to “6
Ω
MIN” as follows BEFORE using this unit.
Note
S P I M P . - 8 M I N
S P I M P . - 6 M I N