Xerox Digital copier printers - Manual (Page 28)

2
2-4 Printing with Macintosh Computers
8. Click Save after you change the options to make the new settings your default
settings.
For information about these options, see Appendix D "Setting Job Overrides."
9. Click OK to accept your options, and click Print to print.
Printing pages from the bypass tray
You can use the Fiery SI to print manually fed pages on the copier if you want to print
on special paper or transparencies. You can use the Fiery SI to print on 16–24 pound
paper (60–90 gsm), thick paper (28–32 pound/105–120 gsm) or Xerox-recommended
transparencies from the bypass tray. You can also use the bypass tray for paper sizes
such as A6 and 11” x 18” (model 5750 only).
There are several ways to print manually fed pages:
• From the Control Panel, you can set Enable Bypass Tray as default to Yes to print all
jobs from the Bypass Tray unless another tray is specified.
• From within the Fiery XJ Spooler, select a job, choose Override Print Settings and
set the Bypass Tray option to On .
• For many applications, you can use the following procedure and choose Bypass Tray
in the Print or Page Setup dialog box.
T O PRINT PAGES USING THE BYPASS TRAY :
1. Make sure that the Use Bypass Tray option on the copier panel is set to No.
N OTE : If you select Bypass as your paper supply on the copier, the copier will be in
Copier Mode and unavailable for printing.
2. Load paper or transparencies into the bypass tray.
You can load up to 40 sheets.
3. Press the Clear All button on the copier.