Navigating the sine wave plus, Check defaults, Record changes – Xantrex Technology SW Plus 4024 User Manual
Page 134: Navigating the
Navigation
5–2
976-0043-01-02
Navigating the
Sine Wave Plus
The
Sine Wave Plus
is programmed using the inverter control module
(ICM) to access “User” and “Setup” menus. Navigating through the
menus requires an understanding of the ICM and its features, what menus
are required to do specific functions, and to set or change parameters.
Check defaults
The factory default settings may be adequate for most installations.
Check the factory default settings shown on the following model-specific
tables to see if your installation will require changes to these settings:
•
•
•
Table 6-3, “Basic Setup Menu Default Settings for the Sine Wave
Plus 5548 Model” on page 6–6
•
Table 7-1, “Advanced Setup Default Settings for the Sine Wave Plus
2524 and 2548 Models” on page 7–2
•
Table 7-2, “Advanced Setup Default Settings for the Sine Wave Plus
4024 and 4048 Models” on page 7–5
•
Table 7-3, “Advanced Setup Default Settings for the Sine Wave Plus
Plus 5548 Models” on page 7–7
Record changes
If your installation will require that the settings be altered, changes can be
made using the features of the inverter control module. Record these
changes on the model-specific tables provided in
. This provides a written record of the necessary
changes in the event that the inverter needs to be reprogrammed.
•
•
•
Table B-4, “Basic Setup Default and User Settings for the Sine Wave
Plus 5548 Model” on page B–8
•
•
•
Table B-7, “Advanced Setup Default and User Settings for the Sine
Wave Plus 5548 Model” on page B–14
Most installations will require that the user perform the Basic Setup
routine.