Yamaha AV1 - Manual (Page 26)

E-24
Standby mode
While the power is on, pressing the POWER switch
(or the POWER switch on the remote control
transmitter) switches the system to the Standby
mode. (In this mode, the display shows only the
time.) In this mode, main voltage is still present
inside the system. If you want to switch off the
system completely, disconnect the AC power plug
from the AC outlet.
TURNING THE POWER TO THIS SYSTEM ON OR IN THE STANDBY MODE
TURNING THE POWER TO THIS SYSTEM ON OR IN THE STANDBY MODE
If the AC supply lead is connected to the AC outlet, this
system can be turned on and turned into the standby
mode by pressing the POWER switch on the front
panel of the main control unit or the POWER switch on
the remote control transmitter.
• While the power is on, the display on the main
control unit shows the name of currently selected
input source or other information.
In the standby mode, the display shows only the
time.
Automatic function to turn the system into the
standby mode
The power of this system will be automatically turned into
the standby mode if there is no operation on the control
parts of this system, and no playback of CD for about 30
minutes.
* This function is not available unless time setting is
made on the built-in clock.
Direct input source selection
When this system is in the standby mode, pressing an
input selector button will turn the power on and select
the corresponding input source.
MINI COMPONENT SYSTEM AV–1 POWER OPEN/CLOSE CD TUN
/
PUSH OPEN
POWER
SLEEP
VOLUME
TEST
ON/OFF
C/R/D
CENTER/REAR
/DELAY
PRESET
TUNER
CD
DSP
LEVEL
PROGRAM
SUBWOOFER
INPUT
AMP