Cooker King Cooker King Kooker OUTDOOR COOKER - Manual (Page 12)

12
1. Procedures for assembly of all Camp
Stoves is the same, only the number of
burners vary.
2 Place burner frame on side so that the
casting ends are turned upward.
3. Loosen nuts on bottoms of castings and
remove all castings from frame.
4. Remove the air shutter and spring from
the bag and place the air shutter over the
end of the casting venturi tube. Hold the
wide end of the spring against the air
shutter and insert one male threaded end
of the manifold into the end of the venturi
on the casting.
5. Screw casting onto manifold.
6. Repeat steps 4 and 5 with each casting until manifold is complete.
7. Reassemble castings to frame by retightening nuts with manifold attached to castings.
8. Refer to the Instructions for Camp Stove Legs and Shelf Assembly at this time if using legs or
shelves.
9. Refer to the Use and Care Section of this manual for further instructions.
CASTING
VENTURI
TUBES
AIR SHUTTERS
SPRINGS
REGULATOR
MANIFOLD
CAMP STOVE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
ADJUSTABLE WRENCH
LEAK TESTING SOLUTION