ZyXEL Communications Internet Security Gateway 10~100 Series - Manual (Page 65)

ZyWALL 10~100 Series Internet Security Gateway
Firewall Commands 10-7
Chart 10-1 Firewall Commands
FUNCTION COMMAND DESCRIPTION
config edit firewall set <set
#> rule <rule #> TCP destport-
single <port #> This command sets a rule to have the
ZyWALL check for TCP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
config edit firewall set <set
#> rule <rule #> TCP destport-
range <start port #> <end port
#> This command sets a rule to have the
ZyWALL check for TCP traffic with a
destination port in this range.
config edit firewall set <set
#> rule <rule #> UDP destport-
single <port #> This command sets a rule to have the
ZyWALL check for UDP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
config edit firewall set <set
#> rule <rule #> UDP destport-
range <start port #> <end port
#> This command sets a rule to have the
ZyWALL check for UDP traffic with a
destination port in this range.
D D e e l l e e t t e e
config delete firewall e-mail This command removes all of the settings for
e-mail alert.
config delete firewall attack This command resets all of the attack
response settings to their defaults.
config delete firewall set <set
#> This command removes the specified set from
the firewall configuration.