Zap ELECTRIC SCOOTER - Manual (Page 12)

PRE-RIDE CHECK LIST
PERIODICALLY GO THROUGH THIS CHECKLIST TO MAKE SURE THAT YOUR ZAPPY IS
IN PROPER ADJUSTMENT FOR SAFETY AND OPTIMAL PERFORMANCE. IT IS IMPER-
ATIVE THAT YOU REVIEW THIS CHECKLIST BEFORE YOUR FIRST RIDE. ALTHOUGH
YOUR ZAPPY HAS PASSED OUR QUALITY ASSURANCE PROCEDURE, IT MAY NEED
ADJUSTMENT AFTER SHIPPING.
1. Connect the battery power connector to the controller power
connector.
2. Check tire pressure: The tires on your ZAPPY should be at
least 36 psi (pounds per square inch).
3. Be sure all wire connections, especially battery terminals,
are tight.
4. Check the handlebar quick release to see that it is tight.
5. ALWAYS wear your ANSI or Snell-approved helmet.
NOW YOU ARE READY. HAVE A GOOD RIDE!!!
HOW TO RIDE THE ZAPPY
• Practice makes perfect...right? Yes, it does! The more time spent
on the ZAPPY, the easier maneuvering will become. Follow the
foot placement guide below to get yourself started for safe, con-
trolled riding. Practice without applying power for balance.
• Note: If you are left footed, or just looking for a change, place your
right foot in front, and your left foot on the rear of the ZAPPY.
• Be sure to lean forward when giving the starting kicks. When the power
hits the front wheel, the front of the ZAPPY may lift off of the ground!
• Both feet should be on the ZAPPY before power is applied, and the
push scooter needs to be moving.
• Since ZAPPY is a new product, certain jurisdictions are not clear on reg-
ulations. Even law enforcement officers are not clear. Check with your
local agencies and follow all laws. When in doubt, only use the ZAPPY
as a push scooter.
ALWAYS WEAR A HELMET! 11
Fig.8
RIGHT
LEFT