Xerox 701P42722_EN User Manual
Page 66
6 Microsoft Networking
66
Xerox CopyCentre/WorkCentre 118 System Administration Guide
7.
Select [SMB] by selecting [
S] or [T] and then press the <Enter> button.
8.
Select [Port Status] by selecting [
S] or [T] and then press the <Enter> button.
9.
Select [Enable] by selecting [
S] or [T] and then press the <Enter> button.
If necessary, you may change the following settings for SMB:
•
Transport Protocol
•
Print Mode
•
PJL
•
TBCP Filter
Next, establish TCP/IP if you use an IP address for a network.
If IP address setting is unnecessary, press the <Login/Out> button to go to Workstation
Setup on page 67.
1.
Press the <Exit> button once or twice to display the [Network/Port] screen.
2.
Select [TCP/IP Settings] by selecting [
T] or [S] and then press the <Enter>
button.
3.
Select [Get IP Address] by selecting [
T] or [S] and then press the <Enter>
button.
4.
Select [DHCP/Autonet], [DHCP], [BOOTP], [RARP], or [Manual] by selecting [
T]
or [
S] and then press the <Enter> button.
NOTE: Use the DHCP server together with the Windows Internet Name Service
(WINS) server.
If you selected [Manual] in step 4, use the following steps to enter the IP address.
If you selected other than [Manual], press the <Login/Out> button and then go to
Workstation Setup on page 67.
1.
Press the <Exit> button.
2.
Select [IP Address] by selecting [
T] or [S] and then press the <Enter> button.
3.
Use the numeric keypad to enter the IP address in the format “xxx.xxx.xxx.xxx”.
NOTE: Press the <
J> button to move to the next section. Press the <I> button to
return to the previous section.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format.
4.
Press the <Enter> button.
5.
Press the <Exit> button.
6.
Use the same steps as IP address setting to enter the subnet mask and gateway
address.
NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section
as the values for the subnet mask.