ZyXEL Communications ZyXEL ZyWALL IDP 10 - Manual (Page 97)

ZyWALL IDP 10 User’s Guide
CLI Overview 9-3
Table 9-1 Commands Summary
COMMAND DESCRIPTION
stateful <ON/OFF> Enable/disable TCP state check
integrity <ON/OFF> Enable /disable TCP packet state
integrity using this command
tcptimeout <value> Set the maximum TCP idle
timeout (this is how long a TCP
connection is allowed to remain
idle.
pinglen <value> Set up maximum ping length
pingmax <value> wan Set up maximum ping packet
accepted at wan port
lan Set up maximum ping packet
accepted at lan port
policy wan
<ON/OFF> Set up policy check on/off wan
port. Policy checks include both
user-defined and pre-defined
rules.
lan
<ON/OFF> Set up policy check on/off loan
port
Interface link wan 10
<half/full> Set up wan port speed 10 at
full/half duplex
100
<half/full> Set up wan port speed 100 at
full/half duplex
auto
<half/full> Enable auto negotiation
lan 10
<half/full> Set up lan port speed 10 at
full/half duplex
100
<half/full> Set up lan port speed 100;
atfull/half duplex
auto
<half/full> Enable auto negotiation
stealth wan <ON/OFF> Enable/disable stealth mode on
the wan port. Replies to outgoing
traffic are not allowed. When a
port is in stealth mode, you
cannot do remote management
nor policy checks on that port.
lan <ON/OFF> Enable/disable stealth mode on
thelan port
Remote snmp on
<LAN+MGMT/WAN+MGMT/MGMT/ALL> Enable remote snmp access from
LAN+MGMT/WAN+MGMT/MGMT
ONLY/ALL port
off Disable remote snmp access
acl <ip address> Set up access control list ip
address
commnuity ro <value> Set up community read only string