ZyXEL Communications ZyXEL ZyWALL IDP 10 - Manual (Page 98)

ZyWALL IDP 10 User’s Guide
9-4 CLI Overview
Table 9-1 Commands Summary
COMMAND DESCRIPTION
rw <value> Set up community read/write
string
trap
<value> Set up snmp trap
system name <value> Set up remote snmp system
name
trap <ON/OFF> Enable/disable remote snmp trap
trap ip <value> Set up remote snmp trap send to
ip address
ssh on
<LAN+MGMT/WAN+MGMT/MGMT/ALL> Enable remote SSH access from
LAN+MGMT/WAN+MGMT/MGMT
ONLY/ALL port
off Disable remote SSH access
acl <ip address> Set up access control list ip
address
web on
<LAN+MGMT/WAN+MGMT/MGMT/ALL> Enable remote web access from
LAN+MGMT/WAN+MGMT/MGMT
ONLY/ALL port
off Disable remote we access
acl <ip address> Set up access control list ip
address
Get State Get system state (Inline, Monitor
or Bypass).
Log Get device log
System Get system information
Time Get device time
Interface Get interface information
All Get all information
Remote Get remote access information
Reboot Restart the device. Use this
command to also exit debug
mode.
Help Displays a “help” message
Reset Resets the ZyWALL to the factory
defaults and erases all user-
defined policies.
Reset
All As Reset and erases all pre-
defined policies too.
Netstat Display network state
Ping Perform Ping from the ZyWALL