Zanussi ZWD 1680 W - Manual (Page 8)

8
• Draining of water: by depressing the “Start/Pause”
buttont the water of programme “Soak” is emptied out
and the water of the last rinse on programmes with
Rinse Hold
option is emptied out and the laundry
is spun .
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
10 Display
The following pieces of information are shown on the
display:
• Duration of washing programme in hours
and minutes, after you have selected a programme
(for example 2.05) .
The duration is calculated automatically on the basis of
the maximum recommended load for each type of
fabric.
After the programme has started, the time remaining is
updated every minute.
• The washing machine has completed the programme:
this is indicated by a blinking zero.
• The washing machine has stopped with water in the
tub, at the end of a programme with the “Rinse Hold”
option
: this is indicated by a static zero.
• Selected drying time in minutes or hours and
minutes.
1.25
2.05
After starting the programme, the remaining time is
updated every minute.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the “Start/Pause” button, the
countdown begins, and the delay time value decreases
by one unit every hour.
You can delay the start of the selected programme by
up to 24 hours in one hour intervals.
• An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 21-22).
E20