Yamaha CLAVINOVA CVP-505 - Manual (Page 112)

112 CVP-509/505/503/501 Owner’s Manual
3
CVP-509/505:
K
e
yboard Stand Assemb
ly
3
Attach B and C to A.
1 Align parts B and A so that the protrusion fits into the hole.
2 Fix the bottom surface of the unit using two long screws.
3 Fix the side of the speaker box using two short screws.
If the screw holes do not align, loosen the other screws and adjust
the position of B.
4 Fix C in the same way.
4
Fix E to D using two short screws.
5
Attach D to A.
1 Fix D to the bottom surface of A using two short screws.
If the screw holes do not align, loosen the other screws and adjust
the position of D.
6
Raise A to the standing position.
Use the front legs as support to raise A.
7
Install F.
B
B
A
A
B
Attach the parts, pressing B onto A so that
the two fit tightly together.
A
B
Tighten the screws after
attaching the washers to
the short screws.
D D
E E
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key cover.
D D
A
2 Fix the side of the
speaker box using two
short screws.
A A
A A
D D
1 Remove the plastic
cover from D.
F F
2 Untie and straighten out the
bundled cord attached to
the bottom of F.
D D
F
F
3 Pass the pedal cord from
under D to the backside of A.
4 Attach F.
Use three thin screws.