Xantrex Technology C40R/50 Remote - Manual (Page 22)

16 975-0123-01-01 Rev A
To Mount the Remote:
1. Use the remote as a template and mark the positions for the screw
holes. Mark the open area to be cut out for the circuit board.
2. Drill out the four screw’s holes and prepare wire access
opening/clearance. If using a double-gang, non-metallic, outlet box,
install it according to the manufacturer’s instructions.
3. Connect the communications cable (from the C-Series controller).
4. Secure the faceplate using screws (and anchors if necessary).
Figure 10 Mounting the Remote
Mounting Holes
Mounting Holes SAMPLE - Double-gang,
non-metallic, outlet box