Yamaha DVX-S100 - Manual (Page 14)

10
PREPARATION STEPS
In order to enjoy sound and video images with this sound
system, follow the procedures as described below. See
each page for details.
Installing batteries in the remote control (P.3)
Speaker setup (P.11)
• Speaker placement (P.11)
• Installing the speakers (P.12)
Connections (P.14 – 19)
• Connecting TV and audio/video components (P.14)
• Connecting the antennas (P.16)
• Connecting the speakers (P.17)
• Connecting the AC power cord (P.19)
• Turning on the power (P.19)
Adjusting speaker output levels (P.20)
Before connecting components
• Do not connect this unit or other components to the
mains power until all connections between the
components have been completed.
• Be sure all connections are made correctly, that is to
say, L (left) to L, R (right) to R, “+” to “+” and “–” to
“–”. Some components require different connection
methods and have different jack names. Refer to the
operation instructions for each component to be
connected to this unit.
• Insert the plugs properly. The speakers may not output
any sound or may output noise if they are not inserted
properly.
• The name of jack corresponds to input selector.
• The VOLTAGE SELECTOR on the rear panel of this
unit must be set for your local main voltage BEFORE
plugging into the AC main supply. Voltages are
220/240 V AC, 50 Hz. (General model)
After connecting components
• Check them again to make sure they are correct.
VOLTAGE SELECTOR
240V 220V
VOLTAGE SELECTOR
(General model)