Yamaha Drum Trigger Module DTXPLORER - Manual (Page 10)

10
■ Connecting External Devices
CAUTION
Whenever making connections, make sure that the
cable being used is equipped with a plug that corre-
sponds to the jack type on the specific device.
● OUTPUT L/MONO, R Jack (Monaural Standard Phone
Jack)
With these jacks you can connect the DTXPLORER to a mixer or
audio equipment to produce sound from external speakers, or con-
nect the DTXPLORER to audio recording equipment for record-
ing your own performance.
* Use the DTXPLORER’s OUTPUT L/MONO jack when connect-
ing to a device with a monaural input.
● PHONES Jack (Standard Stereo Phone Jack)
Use the VOLUME knob on the rear panel to adjust headphone
volume.
Whenever using headphones, take care not to damage your
hearing. Use the equipment with the volume adjusted to a
comfortable level.
● AUX IN Jack (Stereo Mini Phone Jack)
You can connect the audio outputs from a CD player, or other ex-
ternal audio source, to the AUX IN jack to mix the signal from the
external source with the signal from the DTXPLORER. The com-
bined audio can be sent on to an external device via the
DTXPLORER’s output jacks. This jack can be used when you want
to play along with a favorite tune or perform with friends.
* Use the volume control on the external device (CD player, etc.)
to adjust the volume balance.
Connections
● Some Advice On Connections
• Trigger Input jacks 5 RIDE and 6 CRASH are stereo input
type jacks. These jacks can be connected to switch equipped
pads such as the TP65S, PCY65S, PCY130S, etc.
• 3-Zone pads like the TP65S, PCY150S, etc., can be con-
nected to Trigger Input jack 1 SNARE.
• Pad sensitivity is set in the Trigger Setup Edit’s [TRIG2
Type (Pad type)] setting (P. 25).
• The 8 KICK/9 jack accepts a 2-trigger input using a stereo
cable and jack for L (8) and R (9) signals.
A parallel cable (stereo plug
↔
monaural jack x2) can be
used to input two trigger signals.
Also, if the KP65 kick pad is connected to the
DTXPLORER’s input jack 9 with a stereo cable, the exter-
nal pad input jack on the KP65 can be used as the input for
Input jack 9.