Yamaha Drum Trigger Module DTXPLORER User Manual
Page 22
22
none
No reverb (the same as thru).
hall1 – 5
Simulates reverb in a hall.
room1 – 5
Simulates reverb in a room.
stage1 – 5 Simulates playing on a stage.
plate
Simulates steel plate reverb.
white
A special short reverb effect.
tunnel
Simulates the reverb of a tunnel.
bsemnt
Simulates the reverb of a basement.
* hall, room, or stage effects with larger values produce a
greater effect.
7. Change the Reverb Level
Try changing the amount of reverb that is applied to each input
source.
Use the [>] button to view page KIT7, then rotate the jog dial
to set the reverb level (0 to 127).
8. Change the Decay
Try changing the drum voice’s decay time (the time it takes the
sound to fade out after being produced).
Use the [>] button to view page KIT8, then rotate the jog dial
to set the decay (-64 to 0 to +63).
Positive values produce a crisper sound.
9. Change the Voice Character (Filter Setting)
Try adjusting the filter’s cut-off frequency to change the drum
voice’s character (brightness).
Use the [>] button to view page KIT9, then rotate the jog dial
to set the cut-off frequency (-64 to 0 to +63).
Positive values create a brighter sound.
10. Set the Alternate Group
By assigning voices like the hi-hat’s open and closed voices—
voices that you don’t want to have playing at the same time—
to the same alternate group, the voice that is currently sound-
ing will be switched off when the trigger for the next voice in
the same alternate group is received (after the open hi-hat voice
is switched off, the closed hi-hat voice sounds).
Use the [>] button to view page KIT10, then rotate the jog
dial to set the alternate group (off, 1 to 9).
When this setting is set to “off”, the mute will not be active.
* Some voices such as the hi-hat, etc., already have the alter-
nate group set in their preset settings.
11. Set the MIDI Key ON/OFF
This sets the MIDI note on message’s key on/key off for each
input source.
Use the [>] button to view page KIT11, then rotate the jog
dial to set key on/key off.
norm
key off is not recognized.
hold
Key off is recognized. Every time the pad is
hit switches the key on or key off.
0.0s
to
9.9s Key off is recognized and the time (gate time)
from the key on to key off can be set.
* When this setting is set to “
norm
”, some voices may sound
continuously. Press the [DRUM KIT] button to stop the sound.
12. Save the Original Voice
To save the original drum kit you’ve created thus far, use the
store operation described below and save the kit to the
DTXPLORER’s memory.
Original kits can be saved as a drum kit to the User Drum Kit
(33 to 42) allocations.
* If a different drum kit is selected before the store operation
can be carried out, all changes you have made to the data
will be lost.
12-1. Press the [SAVE/ENT] button. The following display will
appear.
Create Your Own Original Drum Kit
KIT7*
•kick
–
RevLevel=
41
‚
KIT8*
•kick
–
Decay=
0
‚
KIT9*
•kick
–CutOffFreq=
0‚
KIT10*•kick
–
AltGroup=
1
‚
KIT11*•kick
–KeyOn/Off=norm
KIT
save
to
33