Zhone Technologies 6212 - Manual (Page 45)

Local Area Network (LAN) Setup
6212-A2-ZB83-20 6212-I3 4-Port Router User’s Guide 45
Finish Function
After you change any item in WAN Setup, remember to click on the Finish
button to apply the changes and reboot the system.
Local Area Network (LAN) Setup
You can configure the DSL Router IP address and Subnet Mask for the LAN
interface to conform your LAN's IP Subnet. If you want the DHCP server to
automatically assign IP addresses, then enable the DHCP server and enter the
range of IP addresses that the DHCP server can assign to your computers.
Disable the DHCP server if you would like to manually assign IP addresses.
The Save button only saves the LAN configuration data. The Save/Reboot
button saves the LAN configuration data and reboots the router to make the
new configuration effective.
Figure 37: LAN Setup
NAT
You can configure the Virtual Server, Port Triggering, and DMZ Host when
NAT is enabled.
Virtual Servers
A virtual server allows you to direct incoming traffic from the WAN side to a
specific IP address on the LAN side. Click on the Add button to add a virtual
server.