Yamaha CRW4261t-NB - Manual (Page 15)

Chapter 2 - Installing the Yamaha CRW4261t Drive
9
6. Connect the IDE interface connector.
Connect the 40-pin IDE interface connector to the IDE interface
located on the rear panel of the CRW4261t drive.
Position the connector so that the colored line is at pin 1 (your lower right).
7. Connect the AUDIO cable.
Connect the single 4-pin connector (Sound Blaster compatible) to the
sound card.
Connect the 4-pin connector at the other end of the cable (the larger
connector) to the AUDIO OUT connector on the CRW4261t drive.
The polarizing lug should be at the top.
DC IN
PUT
1
5V +
12V +
G
R G
L
AUDIO
OUT
CSEL
SLAVE
MASTER
IDE
INTERF ACE
CONNECT
OR
1
DC INPUT
1
5V +
12V +
G
R G
L
AUDIO
OUT
CSEL
SLAVE
MASTER
IDE
INTERF ACE
CONNECT
OR
1