Zanussi ZWF 12380W - Manual (Page 7)

• Heating phase
During the washing cycle the display shows a temper-
ature icon to indicate that the appliance has started the
heating phase of the water in the tub.
5.3:
• Child safety lock
This device permits you to leave the appliance unat-
tended during it's functioning.
First use
• Ensure that the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene block and any material from
the drum.
• Before the first wash, run a cotton cycle at the highest
temperature without any laundry in the machine, to
remove any manufacturing residue from the drum and
tub. Pour 1/2 a measure of detergent into the main
wash compartment and start the machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 2 and 3 buttons simultaneously for about
6 seconds , the acoustic signal is deactivated (except if
there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
and not to worry that children might be injured by or cause
damage to the appliance. This function remains enabled
also when the washing machine is not working.
There are two different ways to set this option:
1. Before pressing button 6 : it will be impossible to start
the machine.
2. After pressing button 6 : it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously for
about 6 seconds buttons 3 and 4 until on the display, the
icon appears or disappears.
Daily use
Load the laundry
Open the door by carefully
pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them out
as much as possible.
Close the door.
Measure out the detergent and the fabric softener
7