Maintenance, Warning – Zenoah HEZ2500F FR User Manual

Page 19

Advertising
background image

• Always be sure to stop the engine before inspecting the stick edger for problems or

performing maintenance.

• Never alter the stick edger or take the engine apart.
• When replacing parts, always be sure to use only RedMax products or products which

have been certified by RedMax for use with the RedMax stick edger.

WARNING

9. Maintenance

19

BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER

Item to be checked

Response

1

Edging mechanism

• See if attachment is loose

• Tighten screws and bolts

• Check if edges of blades are dull

• Sharpen or replace blades

2

Throttle

• Stiff and difficult to move

• Repair or replace

3

Throttle wire

• Too loose, too tight

• Adjust

• Stiff and difficult to move

• Repair or replace

4

Engine attachment

• See if fittings are loose

• Tighten fittings

5

Fuel tank

• See if attachment is loose

• Tighten screws and bolts

• See if fuel pipe is damaged

• Replace

• See if cap packing is damaged

• Replace

6

Muffler

• See if attachment is loose

• Tighten screws and bolts

7

Cutting blade

• See if damaged or worn shorter

• Replace

than usable length

every every every

25

50

100

system/compornent

procedure

before hours hours hours note

use

after

after

after

fuel leaks, fuel spillage

wipe out

fuel tank, air filter, fuel filter

inspect/clean

replace, if necessary

see

■ADJUSTING

replace carburetor

idle adjusting screw

IDLING SPEED (p.17)

if necessary

clean and readjust

GAP: .025in(0.6~0.7mm)

spark plug

plug gap

replace, if necessary

cylinder fins, intake air cooling vent clean

muffler, spark arrester, cylinder exhaust port clean

throttle lever, ignition switch

check operation

replace if

cutting parts

something's wrong

gear case

grease

screws/nuts/bolts

tighten/replace

not adjusting screws

drive shaft

grease

cutting blade

inspect/replace

replace, if necessary

ENGINE

SHAFT

MAINTENANCE CHART

Maintenance, replacement, or repair of the emission control device and systems may be
performed by any non-road engine repair establishment or individual.

Advertising