Zanussi ZBB26650SA - Manual (Page 12)

4 Remove the lower
door.
4 Loosen the lower pin.
On the opposite side:
1 Install the lower pin.
2 Install the lower door.
3 Tighten the middle
hinge.
4 Install the upper door.
5 Tighten the spacer and
the upper pin.
Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
6 cm
min. 200cm 2
min.
200cm 2
Installing the appliance
Caution! Make sure that the mains cable can move
freely.
Do the following steps:
x
x
1 If necessary cut the
adhesive sealing strip and
then apply it to the appli-
ance as shown in figure.
1
2
2 Install the appliance in
the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
44mm
4mm
3 Adjust the appliance
in the niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen fur-
niture is correct.
Open the door. Put the
lower hinge cover in posi-
tion.
I
I
4 Attach the appliance to
the niche with 4 screws.
12
www.zanussi.com