Lumex Syatems LF2020 - Manual (Page 10)

LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 10
Lift and Transfer From Bed
1. Fit sling as described in “Fitting Lumex
Sit-To-Stand Sling”.
2. Push lift towards patient. Open the base of
the lift. Apply the brakes on both rear
casters.
3. Position patient’s feet on the foot platform
and knees against the knee pad.
4. Attach the sling straps to the hooks.
5. Have the patient’s hands holding the handles.
For patients who cannot hold the handles,
have them hold their arms around the chest.
6. Press the “UP” button on the hand control.
7. Before the patient’s body is lifted from the
bed, stop and make sure the sling is secured
and patient’s knees are against the knee pad.
8. The patient should be comfortable with the
pressure under the arms. If not, adjust the sling
and try another loop option to release pressure.
9. Press the “UP” button until the patient’s body
is completely left the bed.
10. Transfer to another object can be done at this
position without the patient attending a full
standing position.
11.Release the brakes, close the base, and pull
the lift away from the bed.
12. Lower the patient to the object intended.
13. To lift patient in a standing position, continue
to lift until the patient’s knees are locked in a
standing position.
14. At the standing position, patient’s knees may
move away from the knee pad.
15. Close the base, and pull the lift away from the
bed.
16. Lower the patient to the object intended.
17. Reverse the above procedures when lowering
the patient to the bed.